Hello All,

My 19 Axis A22 anchor lights and underwater lights do not work.  I am having trouble locating the fuse box.  I see the fuses under the throttle but nor sure where to remove them. Also it does seem like none of the fuses have popped. Any Idea would be great.

Thanks

I'll admit that I'm in the habit of only pulling my center T handle plug since its the low point in my last 2 boats and is a lot easier to access. When I pull the transom plug nothing ever comes out. I usually only pull the transom plug when going thru a mandatory watercraft inspection station. I probably should just pull them both every time.

(In Utah where AIS is a real concern.)

Interesting.  I always pull my plug when I pull my boat out but never heard it's the law in Michigan.

16 hours ago, UWSkier said:

Unless you have inspection requirements, there should be no need to ever pull the plug, especially the transom plug. 

Isn't it the law that the plug has to be out while you trailer? Pretty sure they added it a while back to help prevent the spread of invasive species. Also handy to have out if you hit a rain storm while you're driving. 

17 minutes ago, ATLAxis said:

Hi new owner of 2017, Axis A20, 120 hrs, 409 engine . The boat is bone stock and I know it’s had limited service. What would be recommendations for service?, I know it had a fresh oil change in filter. Have ran a tank fresh ethanol free gas in it but still seems to idle a little rough. Is this normal?

A good start might be a tune up. Cap, plugs and new wires. I’d also change the vdrive oil so you know it’s been done.