As long as I've been around I'm embarassed to even post this but I need help troubleshooting my no start issue.  Trust me I've been through the no start guide to no avail.

Key to run, fuel pump primes, key to start, relays all click, then nothing.  I've swapped around all 3 relays, batteries are fully charged, I've got 12+V volts at the starter, voltage drops .4v while fuel pump primes then returns to 12+V, shifter is in neutral.

Not sure where else to go from here.

Wow - that is a pretty amazing list of failure in one vehicle.

How many people in the main seating area? Probably need more bow weight. Maybe 400? You are at 6200 ft so that hurts.

Are you trying to control it from your screen?

Are you just wanting to turn it on and off or select colors, combine colors, make the lights change to music, have zones etc. from the factory screen?

How do you plan to use/connect the screen in the system?

What is the "Driver"?

What RGB controller?

I have installed several "Factory" type RGB setups. I've only done it with a controller that can read the full Can Bus signal from the factory screen. I use the Shadow Caster/ Wetsounds controller like the factory uses so it can use the factory screen controls by reading the Can Bus signal. I've never used aftermarket controls, I want it to look like it belongs there. You can do this type install on boats before they were optioned but it's not Plug & Play. I'm certainly not the expert and have no experience with aftermarket equipment installs.

On 10/14/2020 at 6:42 AM, Keef said:

I have a 21 Axis A24 in Miami and use the flush all the time.  Feel free to DM me if you want any info or talk.

I have a 2020 t23, looking to have the saltwater package installed. Just curious where your zinc anodes are/how many and if you have pictures of them or something?