Portable pump fitting?

[dalt1]

Lost the quick connect barbed fitting from my old throw it over the side portable pump. Is the hose size measured from the O.D Or the I.D.?

I see 1 1/8" listed, that is a little larger than my outside diameter.  Don't see 3/4" listed which would be the inside.

Anyone have any old ones laying around? 

https://www.bakesonline.com/fly-high-w738-1-18-barbed-fitting.html

[BlindSquirrel]

@dalt1 hmmm... mine appears to be a little larger hose than yours, , 1 1/4 od with a 1 1/4 od fitting, causing the overall od with the fitting installed to be 1 3/8. Looks like it needed to be heated a little to fit it in. Not sure how to help... but will disassemble if needed.

 

 

[butter71]

Hose and fittings are typically spec'd for the ID, so seems like a 3/4" fitting would be ideal, but maybe the end of the hose could be stretched/flared for this one to work?

https://www.wakemakers.com/collections/wakeboard-ballast-fittings/products/fly-high-pro-x-series-fitting-w738?_pos=4&_fid=364f0285d&_ss=c

 

[dalt1]

I think back in the day when trying to sink your boat was a new idea, a lot of the pumps were smaller. This one has been around a few years. Use it for a boat bailout pump when needed. Still want to be able to hook it to this bag though.

[Brad B]

I changed to 1" ID braided hose to prevent kinks. Used stainless hose clamps and then shrink.