Jump to content
Sign in to follow this  
PSchenk

MXZ exposed seat bases?

Recommended Posts

PSchenk

As you all know, the MXZ seat bases are the exposed gel coat instead of carpet. We just got our boat and already have a few small scratches on the inside from activity in the boat. Has anyone with an MXZ installed any material to cover the majority if the seat bases? I'm thinking about getting some rectangular SeaDek sections that match the platform to slap on there. That way there will be something to protect the majority of the exposed glass. Thoughts?

Share this post


Link to post
Share on other sites
nyryan2001

wouldnt reccomend that... kinda overkill and over everything. Do you have white gel there?

wipe it down well with your spot remover, Hot Sauce etc etc....if you have marks on there gently use a Mr Clean Magic Eraser....gently... its slightly abrasive, light rub

use a mild abrasive polish and buff out any permanent gel scratches with a buffer in the spring and perhaps mid-summer..... enjoy your boat

Share this post


Link to post
Share on other sites
PSchenk

it's actually a charcoal floor. We will just have to get used to being more cautious in there. We had the carpeted bases before.

Share this post


Link to post
Share on other sites
DarkSide

Another solution would be to install clear bra over these areas. A 12x60 sheet is $38 on Amazon. I had this installed on the transom to protect against boards hitting the back while putting them on. I didn't think about the inside...may have to do that next....

To the lake, go we must.

Share this post


Link to post
Share on other sites
saidainc

Another solution would be to install clear bra over these areas. A 12x60 sheet is $38 on Amazon. I had this installed on the transom to protect against boards hitting the back while putting them on. I didn't think about the inside...may have to do that next....

To the lake, go we must.

What is the installation difficulty level?

Edited by saidainc

Share this post


Link to post
Share on other sites
DarkSide

I don't think it would be hard on a flat surface. I paid to have my transom and swim step covered. Too many things to cut around and odd shapes for me to try. I will try the inside referenced here. I don't think it would be that bad.

To the lake, go we must.

Edited by DarkSide

Share this post


Link to post
Share on other sites
oldjeep

The vtx has the same thing and I put a nice scratch in mine when removing the seat for a riser measurement.

some spectrum gel repair is in my future

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×