Am I the only one?

[justincox28]

2008 Wakesetter VLX

Indmar Monsoon

Two bad post cat temp sensors

Installed 470 ohm resistors to bypass temp sensors (fixed that problem)

ECM update as of June 2010

Throttle update

This is really starting to bother me. After updating the ecm, every time I start the boat I turn the key one click and wait for all the gauges to cycle then turn on the boat. As soon as it fires up I get a service required message and an audible beep. It then goes away and does not register a fault code in the computer. My dealer says this is normal and there is nothing they can do. I called Malibu directly and got the same story. Now for $60K I don't think I should deal with this. Its also embarrassing when master craft and nautique owners are with me and see that message. Does any one else have this problem? If so, are there any fixes? I am tempted to purchase the diacom software and adjust the values for the post cat temp sensor range as I think this is what is causing it (but who knows). Please help....

[G-Mack]

not normal... I have the resistors installed and ECM updated in June 2010... no warning