Jump to content

 

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

Sign in to follow this  
sunsetskier

Help locating engine components

Recommended Posts

sunsetskier

I need to locate the Idle Air Control, the MAP, the TPS and the oil pressure sender on my Monsoon 335 EFI motor the boat is an '03 RLXi.

Can anyone help with this. I have looked to Indmar's web site but all that info is dealer only.

Thanks

Share this post


Link to post
Share on other sites
sunsetskier

I would pay dearly for a PDF pointing out all the engine components of this motor right now.

Share this post


Link to post
Share on other sites
VinRLX

Oh, don't say that. There's lots of folks here who will just take pictures and put arrows to the parts. Hang tight. I'd do it myself if I knew where they all were!

Share this post


Link to post
Share on other sites
SunriseH2OSkier

I'd go get pics, but it is dark and raining here at the moment. In the meantime:

The TPS sensor should be located right on the shaft of the throttle blade (follow your throttle cable to the end), probably on the port side of the throttle body. Should have 3 wires going to the connector.

The IAC valve should be located close by the TPS, on the engine side (vs. the air filter side) of the throttle blade. Again, I think this device has 3 wires going to it.

IIRC, the oil pressure sensor should be located near your oil filter. Sensor has 3 wires, oil pressure switch probably has a single wire connected to it.

Don't remember seeing the MAP sensor in any readily visible location. But it most likely sits on top of the engine mounted to the intake manifold, underneath the big cover with the Monsoon 335 emblem, towards the back (throttle end) of the motor.

Share this post


Link to post
Share on other sites
sunsetskier

Thanks sunrise.

Easy enough and what I had predicted, but just wanted some confirmation.

One last question.

Since mt guages are reading 0 oil pressure. Is there an easy way to verify that I do have some oil pressure and the the sender/wiring is probably the culprit?

Appreciate it.

Share this post


Link to post
Share on other sites
aneal000

The oil pressure sensor I belive is actually in the rear of the motor, just forward of the transmission on the top side. At least it was on my 310hp.

Share this post


Link to post
Share on other sites
SunriseH2OSkier

If your engine was running for any length of time with the gauge showing zero pressure, it's a sender or wiring problem.

Share this post


Link to post
Share on other sites
jgouveia3

the oil pressure sending unit on my '00 monsoon is on the port side of the engine, right about mid way from the front and the top.

Share this post


Link to post
Share on other sites
sunsetskier

Thanks to all. I have found everything.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...