I have a 2011 wakesetter vlx and there doesn’t appear to be a sensor for the wedge.

The wedge worked last year after I bought it and would show on the display the wedge going down/up, so it must sense it some how but this year the wedge is in a bind and while I’m getting that fixed, I noticed there’s no sensor attached to the side of the wedge. There’s only two wires from the actuators going into the boat, so does anyone know if there is another sensor option for these boats?

https://share.icloud.com/photos/07e4FfiKxgeIfqLH9268dx0Cw

Good photo's. Agree on your points. From what I see, that trailer absolutely needs addressed immediately, but looks easy. The tranny also looks easily fixable. 

Hello, does anyone have the manual for a 2023 tower speaker amp? Trying to figure out rca and remote wire to connect a syn 2. Thank you

4 hours ago, rennis said:

I suspect KPMG's audit procedures aren't protecting MBUU much in this scenario unless they performed interim audit procedures for the 6/30/24 audit on Tommy's as a major customer.  Even if they were I doubt it has any bearing on this situation.

Yeah, the FS audit would provide no assurance for this situation. Even if it was audited by an actual Big 3 firm.

Hello everyone, I am a new owner of a 2010 beautiful Malibu response mint condition . Any recommendations on oil brand , viscosity and recommended filter? On my previous boat  1992 correctcraft sport Nautique I always use Castro 10-40  oil with the wicks filter for over 20 years and always had good luck with it .
thanks