I have a 2019 25' LSV. I noticed lately that my port side surfgate has a clearance of about 1/2" from the gate to the swim platform. The starboard gate is touching the swim platform. Is there a way to adjust the clearance between the surfgate and the swim platform?

Why not replace the cap and rotor? Try that

After the initial setup, how long to setup and take down each time? 

Hello! I have a 2010 MALIBU boat with a maliview (display) system. Everything worked fine. I recently had a wire repaired that had come loose from a power wedge sensor. I checked the sensor - everything is fine, it gives correct readings when turning the axis (from 0 to 1023 values). Next, I start the calibration mode, set the lower value (RAW 20 CALC 0), press ENTER, raise the plow all the way up and set the upper value (RAW 456 CALC 197), press ENTER and the calibration is completed. Next, I start checking the plow - I lower it and the arrow on the display steadily drops and stops in the middle of the scale (CALC 100) (i.e. this is the position of the highest wave when the power wedge is activated). Next, the plow itself goes down (while the down button is pressed), but on the scale the arrow remains in the same middle position. I tried several times - the same thing... I.e. The sensor is working properly, but for some reason it only works at half the scale (the upper half). I repeat, before re-soldering the wires, everything worked properly. Please help with advice. Thanks to all!

Everything is the same as it was for the last 5 years.  The plug in the floor ski locker and the plug in the floor cooler box are out and I noticed some water in there but totally drained the boat before we put it in.  I did not re-install the 2 little black plugs in those areas.