One of my running lights was out on my 2016 Malibu trailer for my 23 lsv.  Ordered a few for extras and drilled out the existing rivets.  
 

Went to install and because of the small diameter opening for the rivet, I can’t get my rivet gun flush with the bulb to get the new one installed.  What are you guys using in this situation? I’ve searched around for smaller rivet guns but the heads all seem to be the same size. 

The fill pump flows water through a hose to a vented loop in the starboard bow seat-back compartment and then into the tank.  The vented loop has a one-way check valve which allows air to enter the loop when the fill pump is not running to prevent water from siphoning out of the tank through the fill pump.  If the vented loop is not located higher than the tank, or if the small rubber valve is clogged, then the tank water can siphon back out. 

Appreciate the we are still married quote.  He wanted so bad to yell at me the first two times ( I race sailboats with my dad so I’m not a total newbie) but then he tried the last two times and has a new appreciation! 
I see a new wench, lube, and not emptying the rear ballast three times over while we bring it in…

Giving this thread a bump. I recently purchased an "03 LSV with Wake Logic installed. I'm trying to track down anyone who has knowledge of this system and can help me troubleshoot one of the gates (starboard) not activating.

I've read through the whole manual and am trying to get it in maintenance/manual mode but I don't see where to do that anywhere? Or, how I would even controll the GPS speed zone if I ever wanted to adjust that.

Appreciate if anyone else with this system is willing to help or point me in the right direction to anyone with knowledge about it.

Thanks,

Jordan

@rugger @martinarcher @R1200196

Do the above. You also get GPS speedometer with that kit.