Welcome to TheMalibuCrew!
As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!
-
Recent Posts
-
DylanH 0
Hi guys had a loss here on my power wedge. The other day is working great then all of a sudden stopped and it's stuck down. Even press the buttons I get no power or don't hear a motor or the actuators like I used to. The fuse and that all looks good. I just have no idea where to go from here. are there any other fuses in the boat that I should check other than below the dash? 2008 Malibu 247 LSV. I really appreciate the help.
-
mxmark4 280
-
Skithemidwest 51
I had a similar event last summer that seemed to resolve after we put some heet in the gas, so I am hoping that will work again. In the meantime I wanted to see if the crew had any other suggestions.
Last summer I replaced plugs, cap / rotar, and fuel filter. After all that I tried some heet and that worked. Fast forward to today and I got the same error codes again and the same rough running engine that seems to require about 5-700 more rpm for my typical ski run. This is exactly what happened last summer.
I did recently put a new battery in and added some new 93 octane that wasn't ethanol free about a week ago. Oil pressure, voltage and temp all seem fine when I took the kids out for some tubing after skiing this morning.
Error codes:
oil press spn 100 cm 0 data valid but below normal range 17 oc 127
mapsensor spm 106 cm 0 Voltage short or below normal range 4 oc 127
cyl 1 Misfire spn 65591 cm 0 Mechanical system not responding properly 7 oc 127.
Thanks in advance.
Edited by Skithemidwest -
brucefredette 0
have a wake setter with the 383 hammerhead engine. this year it is lacking power. It used o top out at 52MPH, a couple years ago it was down to 42MPH,. and now this year it is 35MPH. Otherwise it sounds healthy and no codes have been set. I changes the plugs a few years back, not much of an effect. Also changed the air filter... Is there an inline fuel filter I may have over looked. I'm thinking to check the compression and the fuel pressure. So I'm here to ask if anyone knows the fuel pump part number and if there are in line filters then those part numbers as well. Any thing else to check?
-
Cole2001 1,101
Two different size pullers. One for 1 1/4” shafts and the other for 1 1/8”. The larger will work on the small in a pinch.
-
-
Who's Online 14 Members, 0 Anonymous, 271 Guests (See full list)
- scrupulous
- maxfir
- Ssh78
- Skithemidwest
- hunter77ah
- bretcole
- Ronnie
- teamerickson
- DylanH
- IXFE
- trungsc156
- Malaboo
- 2006VLX
- Molarroller
-
Member Statistics
42,648
Total Members8,865
Most OnlineNewest Member
DylanH
Joined