Hello all, newbie here,  having a issue and was hoping for advice, I have a 2015 wakesetter 24MXZ with 427 corvette motor, while on water this weekend i stopped the engine by pressing the button as usual and heard kind of a clunk( NOT VERY LOUD, JUST LIKE A CLIINK). went to start engine back up and when i press the start button it sounds like the starter is spinning but not engaging to anything, its not turning the motor over. any suggestions on what i may have going on? any help would be greatly appreciated.

Here is a video of the fuel pressure when I use throttle only and get it to 1k rpm 

https://youtube.com/shorts/Y4JU9jgjxi8?si=Atnkk5Ig5Pt6W7pp

The dealer we purchased our boat from closed a year after our purchase.  We have been using Tommy’s in Rancho Cordova, CA and have an appointment tomorrow to have our screens replaced (under warranty) along with normal service. 

What I find interesting is when you go to find a dealer on the Malibu website and type in our zip code, we get No Results.    We are in Northern California.  Find it hard to believe the site would not direct me to a dealer, even if it is 300 miles away.

I will post an update tomorrow after our boat is dropped off. Thanks to all who have posted informative updates on the current situation. 

49 minutes ago, IXFE said:

Sounds like they were burning cash on just about everything…

 

 

… except the boats they collected money on

 

Some of that low rate commercial debt rolled over?

Tested the boat on the fake a lake, first key up doesn't get to pressure. 2 or 3 key ups and it starts no issue. Fuel pressure sits on 58 - 57 psi. Hopefully can take it somewhere this weekend and test it under load. SHould they hold pressure when key turns off? i feel like it should t just go straight back down to 0.