Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

  • Recent Posts

    • Is anyone having issues with their cruise control. I have 2024 T220 m5 motor and the cruise is all messed up. If I set my cruise setpoint at 22mph I'm actually going 23.5-24 according to GPS, to obtain 22mph I have to set cruise at 20.6mph. I know you can adjust actual speed on paddle wheel but that's not the issue, it's the setpoint speed, almost like calibration is wrong in setting to control throttle. Does anyone have any ideas, the dealer is checking g with malibu but so far nothing..

    • On 4/28/2024 at 2:29 PM, 604wakesurf said:

      Had the same issue. I opted not to raise the torsion bars as I needed to store the boat in the garage over the winter.

      Made these up. Total bolt on and they have worked great.

      6B2E3783-4A62-4929-A4C6-E32C573A7AEE.jpeg

      Did you actually make those or buy them?

    • On 5/2/2024 at 9:04 PM, Craig98 said:

      I just got a call at 8:30 PM from the service manager at the Tommy's dealership in Fort Worth.  He said they are locking their doors tomorrow by noon and I needed to come pick up my boat or it would be locked up for an indefinite amount of time.  I will be there when it opens!!  I just HOPE it opens.  So now I have a boat (or I damn well better have one!) under warranty (2022) at the start of the season that needs a new surf gate actuator and no way to get it.   Anyone around DFW got info on warranty work?

      I had warranty work done yesterday. Glad I pushed the issue because the lake call manager was trying to push me to next week. They were here (Eagle Mountain Lake) around 9:45 a.m. to replace a port side ballast pump, rear bilge, and clear fault codes. He never said a word about anything. 

    • 2 hours ago, dalt1 said:

      Is that  steel key stock? Needs to be brass.

       

      Agree, it looks like steel, and likely the reason you had a difficult time getting the prop off.  You have good advice on removing the key from the shaft now that the prop is off.  Any marks you make on the shaft will need to be Emory clothed off too. 

  • Member Statistics

    42,332
    Total Members
    8,865
    Most Online
    CraigW
    Newest Member
    CraigW
    Joined
×
×
  • Create New...