Easy 2 wrench job. Just make sure to pre-index the arms on the splined axles. I used a cold chisel to smack a mark into both the axle and arm. I pulled mine to replace a bent axle and greased the shafts for future maintenance if needed. You may have to use a “wedging device” to get the arm off, but it didn’t take much.

Does anyone know what size rear ballast bag comes in the 2015 24 MXZ? I’m wanting to maximize the wake and I believe they’re 500 or 550 pound bags now? Can anyone also tell me what the largest bag is that can fit in the back above the stock, hard tanks?

TIA

Joe

Hi all, my trailer rollers rub my driveway when pulling out or backing in and I'm afraid it's going to damage the driveway soon. So, I was thinking why can't I take the axle hub off the torsion bar and re-clock it so the trailer sits higher. Its new so it should come right apart. Thoughts??

T

1 minute ago, Steve B. said:

Guessing no dealer can sell any new boat at any old price they want to. No way and large corp would allow a dealer to undercut their other loyal dealers. Wishful thinking.

Except that Tommy's is not a dealer any more.

Guessing no dealer can sell any new boat at any old price they want to. No way and large corp would allow a dealer to undercut their other loyal dealers. Wishful thinking.