Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

2021 Malibu 22 LVS Screen will not power on


Recommended Posts

DFedora

Our screen will not power on.  We can start the boat just fine, but have no power to the screens.

Link to comment

what troubleshooting have you done?  Have you tried turning the battery switch to the off position, wait a few seconds and turn it back on?

Link to comment

Just look on the back side of the screens for any loose cables.  It could also be a fuse.  Did this just start happening?  Have you connected with your dealer (they should probably cover this under warranty work).

Link to comment
DFedora

yes just started.   wires look good.  do you know which fuse goes to screen?  yes, our dealership is closed today.  we were hoping to take it out.

Link to comment
Posted (edited)

The breaker for the dash power is in the carpeted breaker compartment under the observer seat cushion and behind the battery switch.  There are two thumb screws and washers that keep the carpeted top panel in place.  Remove the thumb screws and washers, slide the carpeted top panel towards the port and off of the studs, then marvel at the mass of cables and wiring in the breaker compartment.  Push on the center reset levers to close a tripped breaker. 

https://www.dropbox.com/s/yvgqtipavx039es/2021 Malibu breakers_1.jpg?dl=0

https://www.dropbox.com/s/kmhxw8it2o9zzz0/2021 Malibu breakers_2.jpg?dl=0

If that is not the problem, then there is likely a loose connection somewhere.  If you do not have much experience with 12 volt electrical systems it may be a bit overwhelming and best suited for your dealer to handle.

If you get a chance, ask your dealer to go over the location of each breaker, fuse, and the power module circuit reset procedure with you.  It is very important to know these things to safely operate your boat.

Edited by csleaver
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...