Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

Small Crack in (power) Wedge, what can I do?

Recommended Posts

Our boating season is done up here and as I was going through the boat and doing season end maintenance, I noticed a small crack on one of the arms of the power wedge.  

I looked (although pretty briefly) and the only replacement wedge I could find on Bakes was a floating wedge.  Does anyone know where to look for one at? 

...OR...Could I take it to a welder that knows what he is doing and just have him fix it?  It's up near the top (if the wedge was deployed/down) so def don't have to worry about the way it looks up there.




Link to post


I just took my wedge to a skilled stainless steel welder to have him widen the brackets where the actuators attach. This was done  so that I could fit a DIY 3” PVC surf pipe between the actuators. So, I would just take it to a stainless steel welder and have it welded😁  It will be way cheaper!


Link to post
20 hours ago, justgary said:

I would certainly check with a good welder to see what they think.  Please post a decent photo of the damage.

Here's a picture. Just a small crack by where the actuators bolt on.


Link to post

Better get it fixed before using it again - now that you have seen it disaster is imminent!!

  • Like 3
Link to post
3 hours ago, pshirek said:

Here's a picture. Just a small crack by where the actuators bolt on.


Agree with finding a skilled tig welder to take care of that. Cleaning that up weld/fill and should be able to blend it back so it hides the repair.

what concerns me is it appears the crack extends away from the weld joint through the middle of the arm.

Hopefully the crack/ rust isn’t too deep. To avoid contamination in the weld , it will need to grind that section out.


Link to post

Again,  as other have said,  A good Tig welder should be able to do that no problem at all.  Take it off and take it to them.  

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...