Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

2012 Wakesetter LSV - Total Loss of power

Recommended Posts

Thanks for reading. 

we were out yesterday (of course on a holiday) and my boat was throwing a couple low voltage alarms, thought ok time to change the batteries after today or at the very least get them checked. 

then while putting into a beach lost complete power of the boat. I pressed the button to off and made sure we were in neutral and pressed it back and nothing. 

All Ignition fuse’s are good 

safety kill switch is good

bus bar under helm everything is tight

I believe I’ve checked all the obvious stuff but has anyone had this happen? And if so, what was your outcome? 

heading down to the marina as we speak to pull the batteries and get them tested 

Link to comment

It does have the dual switch, I placed to

both, even replaced one of the batteries with a buddies spare to see if it would work and nothing. 

Link to comment

Thank you all for your advice. 

even though starting with the switch, accessing from underneath the dash, all wires seemed fine, I pulled out the dash cluster and noticed a wire was off of the helm power switch. I connected the wire and made sure all the other wires were attached and bam power again. Thankful it was something small! Thank you all! 

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...