Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

How'd you wire your skylon tuna tower speakers?


Recommended Posts

Tough one to answer with no details about what specific speaker pods, you have. Some have external binding posts, so you could do a single hole between each pair that would service both pods on each side, while some have the wires through the center of the clamp/pod so the wiring is all concealed once the pod is installed. This requires a hole for each pod. This does not even factor in the amp and the impedance of each pod. This can result in a couple different wiring configurations. 

Link to comment

I have JBL tower speakers, that clamp on. I have the wiring ran externally right now till I figure out the best way to route wiring internally.. I have the AMP Config figured out. I'm just trying to see how everyone else wired their wires down the inside of the tower and how the ran them into the boat from inside the tower so they come out clean and barely concealed. 



Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...