Shower Hot/cold

[STX22]

I have a 2012 Response TXi I have been meaning to install a shower in. Finally getting around to it. Boat has the Monsoon with knock sensors on both port and starboard. 

Can someone send a picture of the hot water (and cold although I think that T goes after raw water intake.)

I am using a heater craft setup I pulled put of my old boat. 

Any pics would be greatly appreciated!

[hawaiianstyln]

I didn't install this but it’s easy to snap pics

[STX22]

Thanks for the quick response! Can I ask where that mixing valve is located?

[hawaiianstyln]

It is located inside the Vdrive area for my VLX on the inside wall starboard side

[STX22]

Gotcha. That's why it looks unfamiliar.

Is the cold water T before or after the water pump?

 

I have to halt the project due to a snow storm. This is ridiculous.

[hawaiianstyln]

19 hours ago, STX22 said:

Gotcha. That's why it looks unfamiliar.

Is the cold water T before or after the water pump?

 

I have to halt the project due to a snow storm. This is ridiculous.

that cold water T on mine is after water pump.  The pic shows T on the hose that is connected to my outbound flow of my impeller housing.

Yah, I can't believe the weather, I heard they got snow an hour or so north of me.  We got lucky with just a cold rain.

[STX22]

On 5/10/2020 at 11:34 AM, hawaiianstyln said:

I didn't install this but it’s easy to snap pics

Anyone know what size brass fitting is used for the hot feed?  I had to drill mine and am still fighting with it.  Not convinced that the fitting I cannibalized from my old boat will fit. 

Thanks. 

[STX22]

The never ending project... Does anyone have a picture of their switch setup on a Response 2012 or later?  I have determined  that it is beyond my pay grade to ever tap into the MTC to run the shower pump.  Next option will be a switch.  Looking for either factory or aftermarket mod ideas. I currently have my shower tentatively in the rear port locker.