Wetsounds Talkback Mic mount

[jonthefireman]

Looking for ideas, suggestions, hardware for mounting the WS talkback mic where it's decently accessible and easy to get on and off.  Ideally I'm looking to mount it next to the throttle, but struggling with a bracket idea.  TIA

[wdr]

For my ‘10, I made a “P” shaped bracket out of SS from a bbq grill door I had and attached it to the existing walkway panel bolt that stuck through. It covered up the dangerous and ugly bolt and put it in a good location. Your location may not give you that option.

[jonthefireman]

2 hours ago, wdr said:

For my ‘10, I made a “P” shaped bracket out of SS from a bbq grill door I had and attached it to the existing walkway panel bolt that stuck through. It covered up the dangerous and ugly bolt and put it in a good location. Your location may not give you that option.

Thanks, I will take a look at that spot.  I'm doing the same as you, looking around the house for something similar I can fabricate into a bracket!

 

[MLA]

CB store and convert the alligator clip to a regular CB MIC mount.

[timmypop]

I did strong Velcro on my last one. Will do it agin on the new build this year. 

[Eagleboy99]

Neodynium magnets.

[Brichter14]

Mine is exactly where the one above is mounted

[wedge88]

In our A22, I just draped the cord around the center window support so I could grab it quickly with kids behind the boat.  Didn't leave any marks and unplugged it when trailering.

[Cole2001]

I never mounted my mic. The 420 is mounted under the dash and the mic is just hanging over the throttle, surprisingly it’s actually not that bad there.