Looking for images of starter connections

[Gara]

Hello I just got a new starter for my response with the LS one engine and seem to have lost my photo for where the wires are connected. Would anybody be able to post a photo?

 

 On another note, I did not get as perfect a meeting up of the starter to the block as I had on the original but I’m hoping it is tight enough. 

[justgary]

From what I can see, put the big wire on the top big post and the little wire on the right post with the loose nut.

Why didn't the starter mate to the block?  Maybe loosen it and wiggle it around to mate it better. 

[Gara]

 Thank you, just Gary. I’m sorry I missed your response as I was traveling. I will try it in the next day or two.  

 My question is that there are actually two smaller wires. I have not found a set up like that on any of the Chevy Corvette sites or other Malibu sites.  I know when I took them off, they were on the same post. But anything I find has them on different posts. I’m not sure if I could fry anything if I put them on on incorrectly. 

I’m not sure why it doesn’t mate up perfectly. It actually seems to mate up perfectly until I put the bolts in and then the bolts move it around. I’ve put it on and off three times. I may do one more try.