Float in 2010 LSV water hardtanks

[Ryan1776]

Can anyone tell  me what float is in the tanks?
I'm assuming it's similar if not exactly a fuel level float. 
Did some googling and haven't been able to come up with much.

I can only guess that these don't need to be replaced all that often.
 

Edited April 3, 2018 by Ryan1776

[wdr]

A dough nut sliding up and down on a rod is all. A rare failure event. If your fuel level seems to be off it is most like one of two things. The sensor may be bad or if your fuel tank is like mine, it sags where the sensor is seated in the tank. There is a 1/4" side to side difference where the sensor is inserted into the middle of the tank. Not much a high dollar sensor can to do to compensate for  sag, tank swell etc.. I just make sure to never get below a 1/4 tank full.

[Ryan1776]

Got it. Wasn't worried about the fuel, just wondering about the ballast. Didn't know if anyone knew of a part number. 
Doing a different project and thought this float level might work. 

However, 
 

6 minutes ago, wdr said:

There is a 1/4" side to side difference where the sensor is inserted into the middle of the tank. Not much a high dollar sensor can to do to compensate for  sag, tank swell etc.. I just make sure to never get below a 1/4 tank full.

This is good/interesting info. 

[wdr]

I have not seen a PN on anything ballast related on mine. Go to the Moeller web site they build the fuel tanks and maybe the ballast tanks but I am not sure about that. They might have that info.

[Ryan1776]

Awesome! Thank you. 

[wdr]

Moeller does sell the different length sensors. Didn't see a price though.