engine fault check transmission alarm

[lakeparkmalibu]

Hey guys and gals, I am new to the "Bu" family, just bought a 2008 Vride with 116 hrs on it about 4 weeks ago. Boat has been perfect for the 50ish hours we have put on it in that time. Saturday we jumped in, idled to middle of lake to fill sacs and I got an engine alarm then check transmission of my display. I shut down, checked fluids, (ie. transmission, it was full, not cloudy, did not appear  to have water in it) so we motored around the lake a little, The boat is running/shifting fine.... runs like a new.... but every time I turn switch off and then start up again, I get the fault code.... any ideas?

[oldjeep]

Bad temp switch? Really just guessing unless you can hook it up to diacomm and see the sensor values.

[lakeparkmalibu]

engine temp, oil pressure, voltage are all good..... I have a sneaky suspicion that its just a sensor on the tranny that is sending a faults code.... anyone know where any sensors are located???

[oldjeep]

there should be a trans temp sensor, that was what I was referring to.

[lakeparkmalibu]

oh... my bad.... thank you.... I'll check it out tomorrow....