Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

99 Sunsetter LXI shaft packing question


Recommended Posts

I believe 3... if they will fit. If fit three on my Rlxi... made a little tool out of a very short piece of pvc (with a cutout) that I could fit over the shaft then use to push/pack each layer into the nut.

After install, I found it best to put boat in the water and loosen nut to where water was flowing by (thus saturating the gfo material), then snugging up the nut to desired point. I haven't had to adjust since then. The nut will get blazing hot very quickly if it is too tight.

Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...