Jump to content
Sign in to follow this  
stumpf101

Need Help With Illusion XS Speaker Wiring

Recommended Posts

stumpf101

Im in the process of replacing my tower speakers with the hybrid exile system. I have run into two problems. First, I accidentally pulled the speaker wire out of the bottem right hole in the tower (the farthest from where the wire goes in to tower). I don't think I pulled too far, just a few inches where I can't see it. The only idea i have come up with is to fish around in the speaker hole above it, find the wire, and pull it though that hole. Then pull another foot of slack, double it back toward to correct speaker hole, fish aound again and pull it though the correct hole. I knew how much of a disaster it was going to be as soon as I did it, but I cant be the first one to do it. Is there an easier way that I'm not thinking about?

Second Issue is the hybrid setup is 6 tower speaker so 2 go on the rear tube of the tower. I tried to remove the rear tube to drill/ run the wires however i can only find a bolt in the left side. When I stick the allen wrench in the right side it does not grip anything. :dontknow:

If any of this is covered in another post, sorry I have looked for 2 days and didnt find it.

Share this post


Link to post
Share on other sites
ryanbush

Push a piece of stiff wire down from the top, once you get it the the bottom pull the speaker wire out and tape it to the stiff piece of wire and pull the entire section back to the top!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×