Jump to content

Recommended Posts

racer808

I tried to search but only found one thread which did not address the issue. I ordered a new PCV Valve which Bakes confirmed was the correct one for my boat. However, height wise it will not fit & the existing hose does not have a valve (circular portion of valve will fit)? Am I doing something wrong? What is the correct way to install this thing?

Here's what I have now

IMG_20140505_172424_zps98c2f25c.jpg

Here's the new valve

IMG_20140505_172435_zpsd283c57b.jpg

Edited by racer808

Share this post


Link to post
Share on other sites
justgary

Did you pull the correct hose? I haven't checked it, but my engine has a hose on each valve cover, and I think only one is a PCV valve.

Share this post


Link to post
Share on other sites
racer808

I actually didn't check the other side. I am following the hose from the flame arrestor down to the valve cover. Perhaps I need to check the other side.

Edited by racer808

Share this post


Link to post
Share on other sites
racer808

Nope, nothing on the other valve cover

Share this post


Link to post
Share on other sites
WheelerWake

The PCV valve hose is connected to the intake manifold. The one connected to the arrester is a simple vent/breather. Sounds like you don't have the PCV.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×