Replacing tach

[RBC]

My tach died on my 04 wakeseter. I called a dealer and was told the part is avalible, but how does it come out? I don't see any screws holding the cluster cover in place.

[B-GOOD]

I replace mine last summer, very easy. Remoove the litle aliminum bezel in front of the cluster, it's about 1 1/2" long just over the steering.

There is 2 screws (one on each side) once removed, the front panel will come off...

If you are looking for a rpm, there is one on ebay, http://cgi.ebay.ca/Malibu-Boat-RPM-Gauge-5-2000-2005-used-/270667303859?pt=Boat_Parts_Accessories_Gear&hash=item3f05074bb3#ht_500wt_1156

good luck

[99response]

I replace mine last summer, very easy. Remoove the litle aliminum bezel in front of the cluster, it's about 1 1/2" long just over the steering.

There is 2 screws (one on each side) once removed, the front panel will come off...

If you are looking for a rpm, there is one on ebay, http://cgi.ebay.ca/Malibu-Boat-RPM-Gauge-5-2000-2005-used-/270667303859?pt=Boat_Parts_Accessories_Gear&hash=item3f05074bb3#ht_500wt_1156

good luck

There should also be a black screw that goes up into the dash above the center gauge.

So 3 screws and all 3 gauges come right out.

-Chris

[malibu323538]

My tach died on my 04 wakeseter. I called a dealer and was told the part is avalible, but how does it come out? I don't see any screws holding the cluster cover in place.

The instructions are given by others. There are just a few screws and the gauge cluster comes right out. Really very easy. There is also a used Malibu tach listed in ski-it-again.com in the Speed Control section.