How do I find engine hours????

[skihorse]

I just pick up my 2010 promo and have Maliview and ZO. ZO takes the place of the gauge(tach) that normally shows the hours and the Maliview replaces the other source of engine hours. I can't find anything in ZO or Maliview. Do I have to hook into the ECM to get an hour count???

Thanks!

[Bake's Marine]

I just pick up my 2010 promo and have Maliview and ZO. ZO takes the place of the gauge(tach) that normally shows the hours and the Maliview replaces the other source of engine hours. I can't find anything in ZO or Maliview. Do I have to hook into the ECM to get an hour count???

Thanks!

Should be in the maliview - setup - engine - service - hours?

I'm out on paternity leave otherwise I would check a boat in the showroom for you

-Paul

[skihorse]

Should be in the maliview - setup - engine - service - hours?

I'm out on paternity leave otherwise I would check a boat in the showroom for you

-Paul

Thanks, I'll try that out. I also intermittently(sp?) get a high speed wedge down error even though I don't have a wedge and the wedge box IS UNCHECKED in setup.

Edited June 9, 2010 by skihorse

[SmoothWaterMan]

I believe Paul is correct, if you have Maliview it's in setup/maliview diagnostics, and you'll find a little line item "GC hours".

If you don't have Maliview, there is no way to check engine hours on boats equipped with Zero-Off except for Diacom. Although, you could add a tach display under the dash, to use as an hourmeter.

Peter

[skihorse]

I believe Paul is correct, if you have Maliview it's in setup/maliview diagnostics, and you'll find a little line item "GC hours".

If you don't have Maliview, there is no way to check engine hours on boats equipped with Zero-Off except for Diacom. Although, you could add a tach display under the dash, to use as an hourmeter.

Peter

That's it thanks!