Make of Tower

[River Rat]

I thought this was a Skylon Tower, but now I am not sure. Any of you guys that have been around a while recognize what kind of tower is on my boat? I am looking to add some racks and knowing the manufacturer would help. The tube diameters measure 1.9 inches on a micrometer, and I am thinking that is closer to 1 7/8 inches than to 2 inches in diameter??

[water_junky]

I thought this was a Skylon Tower, but now I am not sure. Any of you guys that have been around a while recognize what kind of tower is on my boat? I am looking to add some racks and knowing the manufacturer would help. The tube diameters measure 1.9 inches on a micrometer, and I am thinking that is closer to 1 7/8 inches than to 2 inches in diameter??

That looks like an older Skylon tower, here is a picture of my folding Skylon tower and the tubing is 1 7/8:

[Bill_AirJunky]

T3?

[Pistol Pete]

I have a 2000 wakesetter vlx that has an ECI tower that was the factory install at the time.

I'm pretty sure it's 1 7/8" diameter. Whatever racks you get for an old skool tube tower like that will have some about of adjustability built into the clamp. So, if you measured it and you think it's 1 7/8" then, good enough.

[Pistol Pete]

Another. I like to bring the kitchen sink with us.

[River Rat]

Thanks folks--the Crew pulls through again!

[68Slalom]

Another. I like to bring the kitchen sink with us.

I don't see a sink anywhere

[Pistol Pete]

Another. I like to bring the kitchen sink with us.

I don't see a sink anywhere

Trust me, it's in the boat.

I even bring a spare as a back-up.

[steemin]

Another. I like to bring the kitchen sink with us.

Wow!!

Scott