Welcome to TheMalibuCrew!
As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!
-
Recent Posts
-
athingisathing 0
I found the kit.... this has everything to connect to all the female plugs that plug into amps in the 2023 lsv with a 9502 and 1206.
This kit will have all you need. This and the color code and the bb-10 kit
Thoughts
-
kcpilotpat 0
I have a vibration on a 2001 sunsetter 21. I put a dial indicator on the prop shaft. in front of the strut I had .003 runout. Just in front of the prop I have .035 runout. It looks like it's a b**** to pull the shaft. It's hard to get to the coupling under the Walters V drive. I'm considering trying to straighten the shaft using a hydraulic jack to push up on the shaft. I would do it slowly using the dial indicator to measure the deflection and sneak up on it. Has anyone in the group tried this? Is the shaft easier to get out than it appears to replace the shaft or have it professionally straightened? All input is appreciated. I'll post photos and experiences either way.
Pat
-
csleaver 1,273
Disconnecting/eliminating one connection at a time, or a "wiggle test" (shaking harness wires and connections by hand until the condition changes) are common diagnostic techniques to find intermittent problems.
Edited by csleaver -
csleaver 1,273
On a 2016 Malibu LSV, the boat side switched ignition circuit uses a purple or purple/white wire and is connected to:
The engine harness connector 11 pin D, depth transducer connector 16 pin C, B1 Break harness pin C, kill switch connector 47, fire extinguisher connector 81A, key switch connector 56a pin A, backup camera connector 101 pin 1, shifter connector 46 pin 3, diacom connector 34 pin A, power button connector 36 pin A, stereo connector 92 pin 9, stereo connector 91 pin 9, IO module connector 10 pin 3, surf gate horn connector B2 pin F, and surf gate horn connector 76.
The engine intermediate adaptor harness ignition circuit connects to the round boat harness plug pin D, paddle wheel plug pin C, Deutsche shift harness pin 2, neutral safety harness pin A, and the rectangular engine harness pin 23.
Separating the engine harness, intermediate adaptor harness and boat harness connections may help narrow down where the problem is.
-
CarveItUp228 16
11 hours ago, oldjeep said:The diameter they quote will be the wheel hub ID. So if you have a caliper - just measure it on the one that fell out
OK, not sure I can get in there for a measurement without jacking her up and taking off the wheel. But I can do that.
-
-
Who's Online 19 Members, 0 Anonymous, 164 Guests (See full list)
- The Hulk
- 85 Barefoot
- dspilot
- athingisathing
- dwc032
- bretcole
- jjackkrash
- Lptexastornado1
- BvrGuy
- BLSousa
- TomH
- Mnandi7
- dshack
- NMMalibuFamily
- mcmary
- Livinlogs
- Pnwrider
- OldieWake
- RyanB
-
Member Statistics
42,264
Total Members8,865
Most OnlineNewest Member
Critter86
Joined