On 10/29/2021 at 11:37 AM, cwiley3 said:

csleaver, thank you for sharing this!  Has pretty much all the info i was looking for.

On 10/29/2021 at 11:37 AM, cwiley3 said:

csleaver, thank you for sharing this!  Has pretty much all the info i was looking for.

Csleaver, I’m guessing you are a boat tech or a malibu tech. I have seen your name on several posts. Question on the heater install. Since I have installed it, when I get over about 4000 rpm’s the engine goes into limp

mode. (Yes I used the malibu wiring harness) Could be unrelated but there is an inactive code for low fuel pressure. Today I watched the engine diagnostic and the pressure started at 88psi and went down in the 60’s with full throttle. Is that low enough for limp mode? I might disconnect the heater and hoses and see what she does. 

I found a new $220K MSRP 2023 23LSV for $135K. Looks like the fire sale has begun. Should I take it or wait? No idea what will happen to service in the future.

Doesn’t seem like they are ready to Fire Sale their boats yet.  They are quoting 28-30% off MSRP on leftover 2023’s.  

Hi, looking for a measurement(s) from anyone running a 2014 - 2016 VTX with the "Wakesetter" graphic decal on the side. I have a 2012 and will be doing a logo delete this spring and adding a set of 2014 decals. 

My question is if anyone can provide measurements for vertical spacing from the bottom off the rub rail to the top of either end of the Decal? I would like to get it as close to factory placement as possible. 

Thanks in advance!

18 minutes ago, Cole2001 said:

That sucks! At least it should fall onto the dealers responsibility. That a M or raptor engine?

M5. I hope they take responsibility.