Jump to content

Welcome to TheMalibuCrew!

As a guest, you are welcome to poke around and view the majority of the content that we have to offer, but in order to post, search, contact members, and get full use out of the website you will need to Register for an Account. It's free and it's easy, so don't hesitate to join the TheMalibuCrew Family today!

  • Recent Posts

    • SkipGundlach

      Posted

      19 minutes ago, Steve B. said:

      I've got a Titan III on an '02. I'll get you the measurements over the weekend.

      Thanks!

    • 1 hour ago, Livinlogs said:

      Check if you have at least 1.5” of clearance and go to an 18” prop . 

      I only had 1.15" on my T250 with a 17" 1778.  I thought the "rule" or suggestion was 3/4" minimum.  What's the concensus? 

    • I've got a Titan III on an '02. I'll get you the measurements over the weekend.

    • 3 minutes ago, butter71 said:

      I don't have the measurements you're looking for, but can tell you there is a lot going on under the gunwales.  At least it is true for our 2000 LSV, and I suspect for your VLX also  Basically, you'll find pvc pipe glassed-in on the underside of the gunwale, for carrying wires, etc...  As a result, installing tower mounts in this already tight, congested area is a challenge.  We used a dremel type tool to cut and grind the pvc tube out of the area for the tower mount.  A great deal of caution is needed to avoid damaging the wiring, especially on the starboard side where most of the wiring is carried.  It's a tight, awkward, uncomfortable position to work in, but do-able.  We benefitted greatly from other posts found on this site before taking on the project.

      On the other hand, there was plenty of room to work with for the tower mounts in front of the windshield.  Hopefully you'll find the same with your VLX.

      Best of luck.

      I lived for 15 years on a sailboat with much the same issues, sometimes with conduit but mostly not, and held up with dabs of 5200 taped in place, the tape long gone by the time we acquired her!

      Glassed in PVC might be challenging, but there are other boats with it installed so I suspect that I'll manage ☺

      There's some indication that it might work; this is a similar hull:

       

      Capture.jpg

    • I've heard that on the LT4 you have to consider the idle speed when in gear...it can turn such a big prop that you can be idling at ~10 mph. You have to come in and out of gear a TON when docking, etc. Just something to keep in mind!

  • Member Statistics

    42,190
    Total Members
    8,865
    Most Online
    shalesh12
    Newest Member
    shalesh12
    Joined
×
×
  • Create New...