2010 23LSV starboard ballast pumps not working

[jbjcrash]

I had the rear starboard pump go out so I replaced it. Now neither the full nor the drain pump even turn on.  Need some suggestions. Thanks 

[BlackBluMalibu]

Maybe popped a breaker under the helm????  Check for power at the pumps. If no power, check the breakers.  Good luck!

[BlackBluMalibu]

Also, you may have the plugs/connections wrong,  hopefully not, as this will blow the fuses also.  IIRC, the plugs are all interchangeable and can easily be hooked up incorrectly.  Make sure you trace the wires and have them conected to the correct one. All the best!

[jbjcrash]

No power to the plugs and I have no clue where the fuses are????

[BlackBluMalibu]

Lay on your back and look up to the backside of the steering column. There are two large plastic covers that cover two sets of fuse panels and control boards. Your manual should show the location and which fuse goes to what, but once  you remove the covers the detail is also on the inside of the covers. 

[wdr]

Here you go. Behind the steering wheel.

 

 

Edited April 18, 2018 by wdr
Explanation

[jbjcrash]

Wdr. Thanks so much. The darn cover had me thrown off. 

[jbjcrash]

It was a blown fuse. 

[Sailvi767]

It’s likely the original pump was still working. Maybe had some debris jamming it causing the blown fuse. Always check fuses first if something electrical fails.

[granddaddy55]

This is what makes this forum the best, people sharing their knowledge base , when combined it’s like 1000 little angels looking out for you and not wanting you to go through the same struggle they have already experienced